Tony Huntimer's 433 '68 Phase 4 Camaro project


January 16, 2000

Photo taken the night the Camaro was dropped off (Circa 1-11-95)
What the engine compartment looked like that night (Circa 1-11-95)
Dash torn apart for painting (Circa 3-21-95)
Shot that made it into Popular Hot Rodding Oct. '96 (Circa 1-19-96)
After the Camaro was running (Circa '97)
Old shot of engine when it was a 402 (Circa '97)
At Speed Merchant (on Lincoln Ave.) in San Jose getting new attitude (Circa 12-3-00)
Another shot with sunbursting (Circa 12-3-00)
Shot of same engine stroked to 433 cubes (a 402 BBC stroker)
My new wheels and new stance
New front brakes by Baer
New 2000 Corvette 17x8.5 Magnesium wheels

ULTRA SHORT Clip of dyno run at 6000RPM for those of you with slower connections -rear view - added 3/14/01

ULTRA SHORT Clip of dyno run at 6000RPM for those of you with slower connections -front view - added 3/14/01



Just a note: if you watch the video you don't hear the throttle lift at the end,
you should close the video and re-openit. There is a bug with some media players.
This goes for all videos. Enjoy!

Tony Huntimer's Camaro at Speed Merchant of San Jose, pulling
402HP/460TQ at rear wheels (from rear) -added 3/12/01
WARNING This video is large in size! -6MB

SAME CLIP - but smaller in size an lower quality -3MB




[Home] [Speed Shops] [Machine Shops] [Fab Shops] [Race Tracks] [Tech]
[Parts Manufacturers] [Pictures] [Videos] [Car Clubs] [Racing Associations]
[NEW STUFF!!]

[DISCLAIMER]

Last Changed 03/05/04